2 ICE iS1100
OPERATOR
SAFETY PRECAUTIONS
The following symbols indicate potentially dangerous situations. Always read this information
carefully and take all necessary precautions to safeguard people and property.
The operator’s cooperation is essential in order to prevent injury. No accident prevention
program is effective without the total cooperation of the person responsible for the machine
operation. Most of the accidents that may occur in a factory, while working or moving around,
are caused by failure to comply with the simplest rules for exercising prudence. A careful
and prudent operator is the best guarantee against accidents and is essential for successful
completion of any prevention program.
SYMBOLS
DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people or damage to objects.
CAUTION!
It indicates a caution or a remark related to important or useful functions. Pay careful attention to
the paragraphs marked by this symbol.
NOTE :
It indicates a remark related to important or useful functions.
GENERAL INSTRUCTIONS
Specic warnings and cautions to inform about potential damages to people and machine are
shown below.
DANGER!
- Before performing any maintenance, repair, cleaning or replacement procedure
disconnect the battery connector, remove the ignition key and engage the parking
brake.
- This machine must be used by properly trained operators only. Children or disabled
people cannot use this machine.
- Sharp turns must be made at slowest possible speed.Avoid abrupt turns on incline.
- Keep the batteries away from sparks, ames and incandescent material. During the
normal operation explosive gases are released.
- Do not wear jewels when working near electrical components.
- Do not work under the lifted machine without supporting it with safety stands.
- When working under the open hood, ensure that it cannot be closed by accident.
- Do not operate the machine near toxic, dangerous, ammable and/or explosive
powders, liquids or vapors. This machine is not suitable for collecting dangerous
powders.
- If the machine is equipped with lead (WET) batteries, battery charging produces highly
explosive hydrogen gas. Keep the hood open when charging the batteries and perform
this procedure in well-ventilated areas and away from naked ames.
- When lead batteries (WET) are installed on this machine, do not tilt the machine more
than 30° from its horizontal position to not allow the highly corrosive acid to leak out of
the batteries. When the machine is to be tilted to perform maintenance procedures,
remove the batteries.
To Next Page
Loading...
