Need help?Do you have a question about the Icematic F 125 C and is the answer not in the manual?
Procedure for starting the ice maker for the first time.
Checking high and low refrigerant pressures.
How to adjust the water level in the evaporator.
Procedure for replacing the gear motor magnetic sensor.
Steps to replace the auger, water seal, bearings, and coupling.
Procedure for replacing the entire gear motor assembly.
Steps for replacing the freezing cylinder.
Troubleshooting for a unit that won't power on.
Diagnosing issues when the bin is full but no ice is present.
Troubleshooting for water shortage indication.
Diagnosing issues indicated by red LED warnings.
Troubleshooting reverse rotation or temperature issues.
Diagnosing gear motor rotation or speed problems.
Troubleshooting when the drive motor doesn't turn.
Diagnosing compressor cycling problems.
Troubleshooting causes for reduced ice production.
Troubleshooting causes for wet ice production.
Troubleshooting when the machine runs but makes no ice.
Diagnosing and fixing water leaks.
Troubleshooting sources of noise or chattering.
Diagnosing causes of gear motor noise.
Troubleshooting causes of water shortage.
Detailed steps for adjusting the evaporator water level.
Detailed steps for replacing the gear motor magnetic sensor.
Detailed steps for replacing auger, water seal, bearings, and coupling.
Detailed steps for replacing the auger and water seal components.
Detailed steps for replacing the entire gear motor assembly.
To Next Page
General
