Need help?Do you have a question about the Icematic F 120 and is the answer not in the manual?
Links LED patterns to specific operational issues and their potential causes.
Procedures for receiving the unit and inspecting for shipping damage.
Details on voltage, fusing, circuit requirements, and allowable voltage variations.
Information on water quality, pressure, and the need for filtration.
Specific plumbing requirements for water-cooled models' condenser and ice production.
Guidelines for connecting drain lines, including recommended pitch and venting.
Step-by-step guide for powering on the ice maker after installation.
Explanation of refrigerant flow, phase changes, and heat exchange processes.
Description of the main control board and its status lights (LEDs).
Detailed steps for replacing the auger, water seal, bearings, and coupling.
Detailed steps for removing and installing the freezing cylinder assembly.
Step-by-step guide for replacing the gear motor's magnetic sensor.
Step-by-step guide for removing and installing the entire gear motor unit.
Lists symptoms, possible causes, and suggested corrections for common operational problems.
Continues the troubleshooting guide with additional scenarios and solutions.
Step-by-step instructions for cleaning the internal water system using a cleaning solution.
Final steps and notes for completing the water system cleaning and sanitization.
Scheduled maintenance tasks for the icemaker unit itself.
To Next Page
General
