23
Checkpoints
Maintenance
1. The Ice Maker is designed including an ice container.
2. When the volume of the ice reaches the preset limit,
ice formation is automatically stopped by a detector sensor.
3. When the ice cubes are taken out from the machine,
the ice detector sensor automatically restarts an ice making
cycle to produce new ice cubes.
4. The Ice Maker operates as a fixed system.
1. General Maintenance and Check Procedure
① Please observe the installation and operation instructions provided in this User’s Manual.
② To maintain the proper condition of the Ice Maker and long-term operation without failure,
perform the maintenance procedures provided below;
2. Inspection of the Ice Maker
- Make sure to cut-off the main power supply before servicing the machine.
- Check all the lines and joints to prevent leakage.
- Protect the cooling plate from rubbing against another plate and/or vibrating.
- Do not leave any obstacle near the Ice Maker to allow sufficient ventilation.
- Clean the filter installed on the front side of the product by at least once a month.
Sensor System
Ice Volume Detector Sensor
To Next Page
Loading...
