8
■Provide at least 20cm(7.9”) of space between the product
and the wall.
- Being too close to the wall may cause product failure.
■
For cleaning or servicing, unplug the power cord, close the feed
water valve, and wait until the product comes to a complete stop.
- Otherwise, electric shock or physical injury may result.
■
Remove the dust on the Condenser, which is on the front or side
of the product, at least once a month.
- Heavy dust on the Condenser prevents heat dissipation and deteriorates
the product performance, leading to excessive power consumption
and/or product failure.
■The ambient temperature range must be between
10℃ to 40℃(50℉ to 104℉)
- installation in a cold place 0℃(32℉) or below, freeze break may occur.
- Installation in a hot place 40℃(104℉) or over, product failure may occur.
■The pressure and temperature of the supply water must be
1.4kgf/㎠~5.6kgf/㎠(20psi~80psi, 138kPa~550kPa),
and 10℃~32℃(50℉~90℉), respectively.
- If the pressure or temperature of the supply water exceeds the above specified
ranges, the ice quality may be deteriorated and/or product failure may occur.
■Make sure to connect the product with a cold water line.
- Connection to a hot water line may cause product failure.
■The supply water must be from the city service water.
Warning
To Next Page
Loading...
