Icom IC-207H - Page 19

| Antenna installation
Antenna location
obtain maximum performance from the transceiver, select
iigh-quality antenna and mount it in a good location. A non-
jial antenna should be used when using a magnetic mount.
Trunk-mount
Roof-mount
antenna
antenna
(Drill a hole or use a magnetic mount.)
Gutter-mount antenna——__,_
Antenna splitter
u can use a dual band antenna because a duplexer is in-
illed in the transceiver. However, an external duplexer must
connected when using a separate antenna for each band.
INSTALLATION 2
© Antenna connector
The antenna uses a PL-259 connector.
e PL-259 CONNECTOR
@® Slide the coupling ring
down. Strip the cable
jacket and soft solder.
Coupling ring 10 mm (soft solder)
@ Strip the cable as 10mm son
shown at right. Soft fe ile Sal
solder the center con- =
ductor.
@ Slide the connector
body on and solder it.
@ Screw the coupling
ring onto the connec-
tor body.
(10 mm = %in)
ENGLISH