Icom IC-207H - Page 29

nn a epee eereeicticimmemiaicinalilties
)
)
Transmitting
y CAUTION: Transmitting without an antenna may dam-
, age the transceiver.
y NOTE: To prevent interference, listen on the frequency be-
fore transmitting by pushing [MONI] or [OMONI] on the mi-
4 crophone.
Push [BAND] one or more times to select the operating
band.
) Set the operating frequency. (pgs. 15-19)
¢ Select output power if desired. See section at right for details.
3) Push and hold [PTT] to transmit.
¢ “Gi®” appears.
e The S/RF indicator shows the output power selection.
) ©The operating frequency, etc. are automatically programmed into
a scratch pad memory. See p. 36 for details.
¢ One-touch PTT function is available. See p. 23 for details.
) Speak into the microphone using your normal voice level.
e DO NOT hold the microphone too close to your mouth or speak
) too loudly. This may distort the signal.
; Release [PTT] to return to receive.
}
BASIC OPERATION 4
@ Selecting the output power
The transceiver has 4 output power levels to suit your oper-
ating requirements. Low output powers during short-distance
communications may reduce the possibility of interference to
other stations and will reduce current consumption.
® Push [BAND] one or more times to select the operating
band.
@ Push [LOW] one or more times to select the desired out-
put power.
¢ The output power can be changed while transmitting.
N
von | at
ENGLISH