Icom IC-207H - Page 41

)
CALL
CHANNEL
OPERATION
B Calling up a call channel
ach band has an independent call channel to store a most-
ften-used frequency for quick recall.
) Push [BAND] one or more times to select a band, if nec-
essary.
; Push [M/CALL] once or twice to display a large “C” in the
|} memory channel readout.
¢ While a call channel is displayed, pushing [BAND] toggles be-
tween the 2 call channels.
MI. Lt oF
( (one ee ee c
Large “C” shows a call Small “c” shows VFO mode
channel is selected. was selected from a call
channel.
» Push [V/MHz] or [M/CALL] to exit the call channel.
_¢ \ [J Push [BAND] to select the desired band, if nec-
tJ essary.
| (2) Push [(MR)CALL] for 1 sec. to select the call
| channel.
[3] Push [BAND] to toggle between the 2 call
| channels.
@ Transferring call channel
contents
@ Push [BAND] to select a band, if necessary.
@ Select the call channel by pushing [M/CALL] once or twice.
e “C1” or “C2” appears—push [BAND] to toggle between them.
@ Push [S.MW] momentarily, then rotate the tuning dial to se-
lect another memory channel to transfer.
¢ To transfer to the VFO, push and hold [(S.MW)MW] instead of
pushing momentarily.
@ Push and hold [(S.MW)MW] to transfer when a momentary
push was used in the previous step.
MW [1] Push [BAND] to select the desired band, if nec-
A essary.
Push [(MR)CALL] for 1 sec. to select a call
channel, then push [BAND] to select the other
call channel, if desired.
Push [FUNC], then [@MW] momentarily.
¢ To transfer to the VFO, push [FUNC] then [@MW] in-
stead of pushing [A©MW] momentarily.
[4] Push [FUNC] then [@MW] for 1 sec. to transfer
when momentarily pushing [@MW] in step G3).
=
2
”
a
i.e)
za
Lu