Icom IC-207H - Page 42

7 CALL CHANNEL OPERATION
Programming a call channel
In addition to an operating frequency, duplex information and
subaudible tone information (tone encoder or tone squelch
ON/OFF and its frequency) can be programmed into a call
channel.
@ Push [BAND] to select a band, if necessary.
@ Select the call channel by pushing [M/CALL] once or twice.
( “C1” or “C2” appears); then push [BAND] to change the
call channel, if desired.
@® Set the desired frequency in VFO mode:
> Push [VFO] to select VFO mode.
> Set the frequency using the keypad.
> Set other data (e.g. offset frequency, duplex direction, subaudi-
ble tone encoder ON/OFF and its frequency), if required.
@ Push [(S.MW)MW] for 1 sec. to program.
VY CONVENIENT
The call channel can also be programmed from the VFO «
rectly (similar to memory programming).
MW
A
41] Push [BAND] to select the desired band, if ne
essary.
Push [(MR)CALL] for 1 sec. to select a ci
channel, then push [BAND] to change the a
channel, if desired.
Set the desired frequency in VFO mode:
¢ Push [VFO] to select VFO mode.
¢ Set the desired frequency using the keypad.
e Set other data, if required.
[4] Push [FUNC] then [@MW] for 1 sec. to of
gram. |
|
[EXAMPLE]: Programming 145.120 MHz into the VHF call channel via the microphone.