Icom IC-207H - Page 43

)
\
& What is a scratch pad
) memory?
uring VFO operation, the transceiver automatically memo-
\zes operating frequency information, separate from regular
nemory channels, when transmitting on a new frequency.
)
‘he 5 previously operated frequencies for each band can be
scalled (L1 to L5 appear for simplex frequencies; r1 to r5 ap-
ear for duplex frequencies.
i Newest
‘
‘
‘
1
'
'
‘
'
'
U
‘
t
‘
| Order is changed if
/ transmitting on this
channel.
oa ;
Oldest
The oldest written frequency is cleared.
Y NOTE: When memory mode is selected, the frequency is
Z not programmed into a scratch pad.
SCRATCH PAD MEMORY
@ Calling up a scratch pad
memory
® Select the call channel by pushing [M/CALL] once or twice.
(A large “C” appears.)
¢ To transmit on the scratch pad memory, select the desired band
in advance.
@ Rotate the tuning dial to select a scratch pad memory.
e Previously transmitted frequency and one of “L1—L5” appears for
simplex memories (rotate [DIAL] left); one of “r1—r2” appears for
duplex memories (rotate [DIAL] right).
e When first applying power or after CPU resetting, scratch pad
memories contain no data and therefore cannot be accessed.
@ Push [V/MHz] or [M/CALL] to exit the scratch pad memory.
r
e The 5th scratch pad memory will be cleared when trans-
mitting on a new frequency. If the transmit frequency is
already stored in a scratch pad memory, the scratch pad
memory is not cleared but the order is changed.
e When transmitting on a scratch pad memory, the scratch
pad memory becomes the 1st scratch pad memory and
the order is changed.
MMMAAAQOA AA
S aa
ENGLISH