Icom IC-207H - Page 44

8 SCRATCH PAD MEMORY
{ \ G1) Push [BAND] to select the desired band, if nec-
CALL
lw essary.
Push and hold [(MR)CALL] to select a call chan-
nel.
Push [W] one or more times to select a duplex
scratch pad memory.
e Once entering a scratch pad memory, [4] can also
be used for selection.
Push [MR] or [VFO] to exit the scratch pad
memory.
@ Transferring scratch pad
memory contents
Transferring scratch pad memory contents to the VFO is done
similarly to transferring regular memory/call channel contents.
MW
S.MW
Push for 1 sec.
——= =
MW
un A
then
ff
\
(
@® Push [BAND] to select a band, if necessary. (
@ Select a call channel by pushing [M/CALL] once or twice.
e A large “C” appears.
@ Rotate the tuning dial to select the desired scratch pat
memory.
¢ One of “L1”—“L5” appears.
@ Push [(S.MW)MW] momentarily. {
e“) _ ~ ” flashes to indicate VFO as the transferring channel.
(
© Rotate the tuning dial to select the desired memory chan
nel if required. (
© Push and hold [(S.MW)MW] to transfer.
Push [BAND] to select the desired band, if nec
esSary.
Push [(MR)CALL] for 1 sec. to select the cal
channel. {
Push [¥] one or more times to select the de
sired scratch pad memory.
Push [FUNC] then [@MW] momentarily.
e“@_ ~ ” flashes to indicate VFO as the transferring
channel.
Push [A] or [¥] to select the desired memon
channel if required.
[6] Push [FUNC] then [@MW] for 1 sec. to transfer