Icom IC-207H - Page 46

teeing a it tan gett erm cee
Q SCAN OPERATION
@ Scan start/stop
© Pre-operation
«Common setting: scan resume condition. (p. 43)
¢ For programmed scan: program the scan edges. (p. 40)
¢ For memory scan: program 2 or more memory chan-
nels; set memory skip settings, if de-
sired. (p. 42)
© Operation
@ Push [BAND] to select a band, if necessary.
@ Select VFO mode for full/programmed scan with the
[V/MHz] switch; or memory mode for memory scan with the
[M/CALL] switch.
@ Set the squelch to the point where noise is muted.
@ Push @@M9 for 1 sec. to start the scan.
e When the tone squelch is in use, @@&9 starts a normal scan—
not tone scan.
¢ To change the scanning direction, rotate the tuning dial.
e The memory channel readout indicates the scan type as follows:
During full scan
Push
to select full scans
and scan edge
pairs in sequence.
|
(
During programmed scan
/
A Indicates scan edge channels.
e P1 stands for 1A/1b.
¢ P1 to P5 are available when
they are programmed.
During memory scan
© To select the scan range while operating Meliss
scan, push [BAND] several times.
© To stop the scan, push [VMHz]. (
Oe 41] Push [BAND] to select the desired band, if nd
3 esSary. (
[2] Push [VFO] to select VFO mode for full/pri
grammed scan; or push [MR] to select memdé.
mode for memory scan. (
[3] Push [OASQL] or [®WSQL] one or more time
to set the squelch just closed. (
Push [@SCAN] to start the scan. (
e [A]/[V] also start the scan when pushed and held
oe [5]To select the scan range while operati(
full/programmed scan, push [BAND] oer
times.
[6] To stop the scan push [@CLR].