Icom IC-207H - Page 47

)
A
SS
SR SS
SEES
)
})
J
a” Programming scan edges
Jean edges can be programmed in the same manner as
yemory channels. Scan edges are programmed into pairs of
ran edge channels, 1A/1b to 5A/5b, in memory channels.
; Push [BAND] to select a band, if necessary.
2) Set the desired frequency in VFO mode:
) =» Push [V/MHz] to select VFO mode.
» Set the frequency using the tuning dial.
) > Set other data (e.g. offset frequency, etc.) if required.
) Push [S.MW] momentarily.
e “@p” and the memory channel number flashes.
(EXAMPLE): Programming 145.30 MHz and 145.80 MHz for the VHF scan edges 1A and 1b.
then » Push
P ush (2 } =~) rotate C}
SCAN OPERATION 9
@ Rotate the tuning dial to select a scan edge channel (1A to
5A).
© Push [(S.MW)MW] for 1 sec. to program.
¢ 3 beeps may sound and the frequency is programmed.
e Scan edge “x”b is automatically selected when continuing to push
[(S.MW)MW] after programming.
© To program a frequency for the other pair of scan edges,
1b to 5b, repeat steps @ to ©.
¢ If the same frequency is programmed into both scan edges, pro-
grammed scan will not function.
Com Push
{ } Or
\ S.MW
and hold
Program 1b in the same manner.
ENGLISH