Icom IC-207H - Page 48

Q SCAN OPERATION
H 7 » 3 beeps may sound and the VFO contents (including the st
ES Programming scan edges Via audible tone frequency, etc.) are programmed.
the mM icrophone » Memory channel number advances to the next scan edge chi
nel (1b to 5b) when continuing to push [©MW] after progra
mw| _ [1 Push [BAND] to select the desired band, if nec- ming.
A essary. [6] To program a frequency for the other scan edge chann
Set the desired frequency in VFO mode: repeat steps [2] and [51.
» Push [VFO] to select VFO mode.
> Set the frequency using the keypad.
Push [FUNC] then [@MW] momentarily.
Push [A] or [¥] to select scan edge channels.
Push [FUNC] then [@MW] for 1 sec. to pro-
gram.
[EXAMPLE]: Programming 145.30 MHz and 145.80 MHz for the VHF scan edges 1A and 1b.
OIE =
aes (xx) Hien rus eo momentarily
(4.9)
MW
Push (v (0) a) Push then for 1 sec. and
continue pushing
Program 1b
in the same
manner.