Icom IC-207H - Page 55

i Transmitting a DTMF code
Using the DTMF memory function
(automatic transmission)
ne selected DTMF code is transmitted at each push of the
TT switch when the DTMF memory encoder is turned ON.
) Push for 1 sec. to turn the DTMF memory encoder
ON.
e “d’ appears in place of the 100 MHz digit.
} Push [SET] to enter the programming condition.
) Rotate the tuning dial to select the desired DTIMF memory
channel.
) Push [PTT] to transmit the selected DTMF code.
e At each push of [PTT], the selected DTMF code is transmitted.
)e The speaker emits the DTMF tones sent.
} Push for 1 sec. to cancel the function.
e “d” disappears.
)
Cis Push [FUNC] then [O©DTMF] to turn the DTMF
DTMF memory encoder ON.
ee / e “d” appears in place of the 100 MHz digit.
| Push [®SET] to enter the programming condition.
Push [A] or [W] to select the desired channel.
Push [PTT] to transmit the selected DTMF
code.
* Each push of [PTT], transmits the DTMF code.
Push [®CLR] to cancel the function.
)
DTMF MEMORY ENCODER 11
© Transmitting a DTMF memory channel directly
Heoge! Push [FUNC] then [ODTMF] to turn the DTMF
DTMF S memory encoder ON.
hated e “d’ appears in place of the 100 MHz digit.
Push [DTMF-S], then push the desired DTMF
channel number.
°“Q” to “9” and “A” to “D” are available for channel
numbers.
[3] Push [DTMF-S] again to deactivate the DTMF
setting. '
Push [®CLR] to turn the DT[MF memory en-
coder OFF.
¢ When the DTMF memory encoder is turned ON con-
tinuously, each push of the PTT transmits the previ-
ously selected DTMF code.
ENGLISH