Icom IC-207H - Page 56

11 DTMF MEMORY ENCODER
DIME
speed
usne
[NITIAL
SET
MODE
The rate at which DTIMF memories send individual DTMF
characters can be set to accommodate operating needs.
The display shows the fastest
DTMF speed is selected.
@ Push [PWR] to turn power OFF.
@ While pushing [SET] (far right switch), push [PWR] for 1
sec. to turn power ON and enter initial set mode.
@ Push [SET] or [MONI] to select the “dtd” display as shown
above.
® Rotate the tuning dial to select the desired speed as shown
in the table below.
© Push [PWR] momentarily to exit initial set mode.
_DISPLAY | INTERVAL |
dtd-2
dtd-3 cps=
dtd-5 characters/second