Icom IC-207H - Page 57

POCKET BEEP AND TONE SQUELCH
i Pocket beep operation
nis function uses subaudible tones for calling and can be
3ed as a “common pager’ to inform you that someone has
alled while you were away from the transceiver.
- Waiting for a call from a specific station
. Push [BAND] to select a band, if necessary.
. Set the operating frequency.
Program the subaudible tone frequency in set mode.
¢ See p. 26 for programming details.
) Push [TONE] one or more times to indicate “T SQL ((+))”
in the function display.
) When a signal with the correct tone is received, the trans-
ceiver emits beep tones and flashes “((+))”.
¢ Beep tones sound for 30 sec. To stop the beeps manually, push
the tuning dial (or any key).
* “((+))” flashes continuously until step © or @.
¢ When receiving another call while “((+))” is flashing, no beeps sound.
) Push [PTT] to answer.
¢ Tone squelch is automatically selected when transmitting.
Push [TONE] once or twice to cancel the function.
(iw Push [BAND] to select the desired band, if nec-
\8) esSary.
Set the operating frequency.
Program the subaudible tone frequency in set
mode.
* See p. 26 for programming details.
Push [FUNC] then [©T SQL ((:)) ] to turn the
pocket beep ON.
When a signal with the correct tone is received,
the transceiver emits beep tones for 30 sec.
and flashes “((+)) .”
[6] Push [PTT] to answer or push [@CLR] to stop
the beeps and flashing.
¢ Tone squelch is automatically selected.
e Pushing [FUNC] then [®TSQL] also selects the tone
to squelch.
Wool (71To cancel the function, push [FUNC] then
4 [OT-OFF].
© Calling a waiting station using pocket beep
A subaudible tone matched with the stations frequency is
necessary. Use the tone squelch on the next page or a sub-
audible tone encoder (pgs. 24, 25).
12
<
”
a
O
=
ui