Icom IC-207H - Page 69

) WIRELESS OPERATION 13
)
licrophone usma INITIAL SET MODE =
ddress © Microphone dip switch 5
@ Remove the switch cover from the microphone rear panel. S
nsceiver has 8 possible microphone addresses (in- @ Set the microphone dip switch and the microphone ad- ue
se to help prevent interference from other HM-90 dress to the same value as shown below.
ESS MICROPHONES. Set both the microphone address @ Replace the switch cover.
el dip switch to the same value as follows. me
TE: When the supplied microphone is connected, the aS oo ee
isceiver rejects control signals from the HM-90 even
en the microphone address is matched.
crophone address
h [PWR] to turn power OFF.
lle pushing [SET], turn power ON to enter initial set
le.
h [SET] a few times to
ct the “Adr’ display as
wn at right.
: ; The display shows the mi-
ate the tuning dial to crophone address is set to 2.
the microphone ad-
3S to O—7 or to turn the microphone control OFF.
ien “Adr-oF” is selected, the transceiver rejects all control sig-
S from the HM-90.
h [PWR] momentarily to exit initial set mode.