Icom IC-207H - Page 70

25 Sas S|
mm
14
OTHER
FUNCTIONS
M@ Beep tones on/off “wa setmove
You can select silent operation by turning beep tones OFF or
you can select to have confirmation beeps sound at the push
of a switch by turning beep tones ON.
@® Push [PWR] to turn power OFF.
@ While pushing [SET], turn power ON to enter initial set
mode.
@ Push [SET] one or more times until “bEP” appears.
¢ Pushing [MONI] reverses the order of selection.
® Rotate the tuning dial to
select the condition.
e“bEP-oF”: Beep tones are
turned OFF.
e“bEP-on”: Beep tones are
turned ON.
© Push [PWR] momentarily to exit initial set mode.
The display shows that the
beep tones are turned ON.
(
(
@ Time-out timer iene INITIAL SET
(|
To prevent accidental prolonged transmission with the
touch PTT function, etc., the transceiver has a time-out’
This timer cuts a transmission OFF after 3, 5, 15 or 30 r
continuous transmission. This timer can be om an
fault).
Approx. 10 sec. before the time-out timer passes, the\
ceiver emits a beep tone as a warning. (
The display shows that the 5 The display shows iat
min. timer is selected. time-out timer is cancelle
@® Push [PWR] to turn power OFF. .
@ While pushing [SET], turn power ON to enter initi
mode.
/
@ Push [SET] one or more times until “tot” appears.
* Pushing [MONI] reverses the order of selection.
@ Rotate the tuning dial to select the desired time-out tir
turn the timer OFF (“oF”). |
© Push [PWR] momentarily to exit initialset mode.