Icom IC-207H Instruction Manual

PANEL DESCRIPTION 1
SET/LOCK SWITCH [SET(LOCK)]
» Selects SET mode when pushed. (p. 70)
= Toggles the lock function ON and OFF when pushed
and held. (p. 16)
/MONITOR/DTMF SWITCH [MONI(DTMF)]
w Toggles squelch opened and closed when pushed.
(pgs. 20, 24)
“» Turns the DTIMF memory encoder ON and OFF for auto
patch operation when pushed and held. (p. 46)
}OUTPUT POWER/DUPLEX SWITCH [LOW(DUP)]
> Each push changes the output power selection. (p. 22) ® VFO/MHz SWITCH [V/MHz(SCAN)]
as
o
=
O
a
Ww
¢ There are 4 output powers available: low, mid-low, mid-high > Selects and toggles VFO mode and 1 MHz tuning dis-
> Push and hold to select a duplex setting. (p. 24)
>» Starts a scan when pushed and held. (p. 39)
¢ There are 3 duplex settings available: minus duplex (“— DUP” @ FRONT PANEL RELEASE LATCH
appears,
plus
duplex
("+
DUP”
appears)
and
simplex.
While
pushing
this
latch,
slide
the
front
panel
to
the
left
to
|
TONE/TONE
SCAN
SWITCH
[TONE(T-SCAN)]
remove
it
» Each push selects a tone function. (p. 50)
e Tone encoder, pocket beep, tone squelch or tone function
OFF can be selected.
» Push and hold to start/stop the tone scan function.
(p. 52)
1 MEMORY/CALL CHANNEL SWITCH [M/CALL(PRIO)]
> Selects and toggles memory mode or a call channel
(pgs. 29, 34)
» Activates the priority watch function when pushed and
held. (p. 44)
an

Icom IC-207H Specifications

General

Brand	Icom
Model	IC-207H
Category	Transceiver
Language	English