Icom IC-207H - Page 74

14 OTHER FUNCTIONS
@ Packet operation
© Data speed usine INITIAL SET MODE
For packet operation the transceiver can be set to one of two
data speeds: 1200 bps (default) or 9600 bps.
@ Push [PWR] to turn power OFF.
@ While pushing [SET], turn power ON to enter initial set
mode.
@ Push [SET] one or more times until “bPS” appears.
e Pushing [MONI] reverses the order of selection.
@ Rotate the tuning dial to
select the desired data
speed.
The display shows the data
speed set to 1200 bps.
The display shows the data
speed set to 9600 bps.
© Push [PWR] momentarily to exit initial set mode.
OTE:
or 1200 bps operation—
Disconnect the microphone plug from the microp
connector during data transmission, otherwise the
signal and voice signal are simultaneously transmit
MMOH
592
¢
or 9600 bps operation— \
When the transceiver is set for 9600 bps data tran;
sion in INTIAL SET MODE, the microphone signal
tomatically cut. Therefore, it is not necessa\
disconnect the microphone plug from the connec
this case.
¢When pushing [PTT] during data transmission, |
transmission is interrupted and voice signals have |
ity.
SS SSS