Icom IC-207H - Page 73

Jemonstration display
10nstration function is available at power ON. This func-
ives you a quick visual introduction to the function dis-
idicators.
ile pushing [BAND], push [PWR] to turn power ON.
Ye transceiver cycles through a visual tour of the function dis-
ay indicators.
sh any switch to exit demonstration mode and enter the
mal operating condition temporarily.
ITE: The transceiver automatically returns to demon-
ation mode after 2 min. in which no operations are per-
‘med. To deactivate the demonstration display
rmanently, turn power OFF, then while pushing [BAND],
n power ON again.
OTHERFUNCTIONS 14
Mi Squelch delay vane INITIAL SET MODE
During operation, received signal strength often fluctuates.
This can result in annoying repeated opening and closing of
the squelch during reception of the same signal. The IC-207H
has a built-in squelch delay function which helps prevent this.
When both stations are operating from a fixed location, this
function should be set to “short” e.g. packet operation.
@ Push [PWR] to turn power OFF.
@ While pushing [SET], turn power ON to enter initial set
mode.
@ Push [SET] one or more times until “Sqt” appears.
e Pushing [MONI] reverses the order of selection.
@ Rotate the tuning dial to
set the squelch delay to
“L” (long) or “S” (short).
© Push [PWR] momentarily
to exit initial set mode.
The display shows the squelch
delay function is set to short.
<
=
al
10)
Zz
ui
62