Icom IC-207H - Page 80

69
15. MAINTENANCE
@ Fuse replacement
lf the fuse blows or the transceiver stops functioning, find the
source of the problem if possible, and replace the damaged
fuse with a new, rated one (FGB 20 A) as shown in the dia-
gram below.
@ Partial resetting
If you want to initialize the operating conditions without clear-
ing the memory contents, etc., a partial reset function is avail-
able for the transceiver.
While pushing [V/MHz], turn power ON to partially reset the
transceiver.
» Initialized settings: VFO frequency, SET mode settings.
» Retained settings: Memory channels, call channels, offset
freq. in memory/call, DTMF memory, ini-
tial SET mode settings.
@ Resetting the CPU
{
The function display may occasionally display erroneous ii
formation, (e.g. when first applying power). This may
caused externally by static electricity, or by other factors. _
If this problem occurs, turn power OFF. After waiting a fe
seconds, turn power ON again. If the problem persists, pe
form the following procedure.
Partial resetting is alternatively available. See previous se
tion for details.
CAUTION: Resetting the transceiver CLEARS al
memory information, and initializes all values in the trans.
@ Push [PWR] to turn power OFF.
@ While pushing [SET] and [S.MW], turn power ON.
e “CLEAr’ appears and the transceiver is reset.