ADJUSTMENT
DISPLAYED
ITEM
OPERATION VALUE
VD TUNING
(TX)
1
[VCT SET]
1) Connect an RF Power Meter to the antenna connector.
2) Push [SET] key.
–
2
[VCT3 TX]
• Select the item "TXG SET" with [M-CH] control.
(Skip this item)
(Skip this item)
TX TOTAL GAIN 1 [TXG SET] • Push [SET] key. –
2
[14.1 TXG]
1) Connect an RF Power Meter to the Antenna connector.
2) Adjust the TX power using [DIAL].
3) Push [SET] key. (The transceiver transmits automatically.)
50 W
3
[1.91 TXG]
• Push [SET] key. (Beep "Pi!" sounds)
(After 1.5 sec., another beep "Pipi!" sounds)
–
4
[28.5 TXG]
• Push [SET] key. (Beep "Pi!" sounds)
(After 1.5 sec., another beep "Pipi!" sounds)
–
5
[51.0 TXG]
• Push [SET] key. (Beep "Pi!" sounds)
(After 1.5 sec., another beep "Pipi!" sounds)
–
POWER METER
(HF BAND)
NOTE: When the [PoHF SET] is adjusted, the [Po 50 SET] MUST be re-adjusted (or verifi ed) too.
1 [PoHF SET] • Push [SET] key. –
2
[PoHF MIN]
1) Connect an RF Power Meter to the Antenna connector.
2) Adjust the TX power using [DIAL].
3) Push [SET] key.
1 W
3
[PoHF 10]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
10 W
4
[PoHF TUNE]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
10 W
5
[PoHF 50]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
50 W
6
[PoHF 75]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
75 W
7
[PoHF MAX]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
102 W
4 - 5
DC 13.8V ACC
KEY SEND ALC ANT
REMOTE EXT SP
GNDTUNER
AMMETER
(0.1–30 A)
Fuses
30 A
DC power supply
(13.8 V/30 A)
⊕
−
Black
Red⊕
Red⊕
−
Black
−
−
Supplied DC cable
50 ohms coaxial cable
2-conductor 3.5(d) mm plug
(connect)
• SHORT PLUG
RF POWER METER
(120 W/50 Ω)
• TRANSMITTER ADJUSTMENT (continued)
To Next Page
Loading...
