Icom IC-7200

4 - 6
ADJUSTMENT
DISPLAYED
ITEM
OPERATION VALUE
POWER METER
(50 MHz BAND)
1 [Po50 SET] • Push [SET] key. –
2
[Po50 MIN]
1) Connect an RF Power Meter to the Antenna connector.
2) Adjust the TX power using [DIAL].
3) Push [SET] key.
1 W
3
[Po50 10]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
10 W
4
[Po50 TUNE]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
10 W
5
[Po50 50]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
50 W
6
[Po50 75]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
75 W
7
[Po50 MAX]
1) Adjust the TX power using [DIAL].
2) Push [SET] key.
100 W
POCV RATIO
(AM)
1 [AM R SET] • Push [SET] key. –
2
[AM RATIO]
1) Connect an RF Power Meter to the Antenna connector.
2) Adjust the TX power using [DIAL].
3) Push [SET] key.
27.5 W
ALC METER 1
[AL-M SET]
1) Connect an RF Power Meter (or a Dummy Load) to the
Antenna connector.
2) Push [SET] key. (Beep "Pi!" sounds)
(After 1 sec., another beep "Pipi!" sounds)
–
DRIVE GAIN 1
[DRV SET]
1) Connect an RF Power Meter (or a Dummy Load) to the
Antenna connector.
2) Push [SET] key. (Beep "Pi!" sounds)
(After 1 sec., another beep "Pipi!" sounds)
–
DC 13.8V ACC
KEY SEND ALC ANT
REMOTE EXT SP
GNDTUNER
AMMETER
(0.1–30 A)
Fuses
30 A
DC power supply
(13.8 V/30 A)
⊕
−
Black
Red⊕
Red⊕
−
Black
−
−
Supplied DC cable
50 ohms coaxial cable
2-conductor 3.5(d) mm plug
(connect)
• SHORT PLUG
RF POWER METER
(120 W/50 Ω)
• TRANSMITTER ADJUSTMENT (continued)