Icom IC-7200

4 - 7
ADJUSTMENT
DISPLAYED
ITEM
OPERATION VALUE
SWR METER 1
[SWR 1 LD]
1) Connect a 50
Ω
Dummy Load to the Antenna connector.
2) Push [SET] key. (Beep "Pi!" sounds)
(After 1 sec., another beep "Pipi!" sounds)
–
2
[SWR 2 LD]
1) Connect a 25
Ω
Dummy Load to the Antenna connector.
2) Push [SET] key. (Beep "Pi!" sounds)
(After 1 sec., another beep "Pipi!" sounds)
–
ID-APC CHECK 1
[IDAPC CK]
1) Connect a 25 ohms Dummy Load to the Antenna connector.
2) Push [SET] key. (Beep "Pi!" sounds)
(Another beep "Pipi!" sounds, then "TX" is displayed)
–
• TRANSMITTER ADJUSTMENT (continued)
DC 13.8V ACC
KEY SEND ALC ANT
REMOTE EXT SP
GNDTUNER
Fuses
30 A
DC power supply
(13.8 V/30 A)
⊕
−
Black
Red⊕
−
Supplied DC cable
50 ohms coaxial cable
DUMMY LOAD
For [SWR 1 LD]: 50 Ω/120 W
For [SWR 2 LD]: 25 Ω/120 W
2-conductor 3.5(d) mm plug
(connect)
• SHORT PLUG