Receiver
- Set radio to follows
- Frequency: 14.1015MHz
- P AMP: ON
- Mode: USB
- Shift: 0
- Filter 2.4KHz
- Connect RF signal generator to ANT connector
- Connect SINARDER to external SP Jack
- Apply 14.1015MHz signals to ANT connector
- Adjust L513, L721, L722 and L943 for maximum audio output
- Set radio to follows
- Dual watch: ON
- P AMP: ON
- Mode: USB
- Shift: 0
- Filter 2.4KHz
- Set Balance controller to SUB Maximum
- Set sub frequency to 14.100000MHz
- Apply 14.1000MHz signals to ANT connector
- Adjust L613 for maximum RX sensitivity
Mixer balance
- Set radio to follows
- Main Frequency: 0.03000000MHz
- Sub Frequency: 0.03000000MHz
- Connect AF audio meter to external SP jack
- Apply no signals to ANT connector
- Set balance controller to MAIN maximum
- Adjust R516 for minimum audio output
- Set balance controller to Sub maximum
- Adjust R616 for minimum audio output
To Next Page
Loading...
