Icom IC-F1000T

17
BASIC OPERATION
2
■ Setting the Beep level
These instructions are for the non-display type transceivers.
The Beep level is adjustable between 1 and 5, or 1 (linked) and
5 (linked). When a Linked option is selected, the beep audio
level is adjustable by rotating [VOL].
Rotate q [VOL] to turn OFF the transceiver.
Set w [ROTARY SELECTOR] to any channel other than
Channel 16.
While holding down e [Lower], rotate [VOL] to turn ON the
power and enter the Beep level adjustment mode.
P u s h r [Upper] to change the Beep level.
• Repeatedly pushing [Upper] first selects 1 (lowest) to 5
(highest), and then selects the lowest linked level, 1 (Linked) to
the highest, 5 (Linked). Repeatedly pushing [Upper] repeats
the cycle. See the illustration on the right.
• The adjustable range is 1 to 5 or 1 (Linked) to 5 (Linked).
• A beep sounds every time you push [Upper]. Therefore, you
can determine the current level setting by the increasing loud-
ness of the beep that sounds.
• To determine if you have selected a linked level, set [VOL] to
minimum, then push [Upper] repeatedly, listening for the loud-
est beep (level 5). Pushing [Upper] once after the loudest beep
will select 1 (Linked). Repeatedly push [Upper] to select the
desired linked level.
Rotate t [VOL] to turn OFF the power to exit the Beep level
adjustment mode.
NOTE:
This operation may not be selectable, depending on the
presetting, Ask your dealer for details.
[ROTARY SELECTOR]
[VOL]
[Upper]
[Lower]
2
5
4
3
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Upper]