18
5
CONVENTIONAL OPERATION
‘‘
Call procedure
When your system employs tone signalling (excluding CTCSS and
DTCS), the call procedure may be necessary prior to voice trans-
mission. The tone signalling employed may be a selective calling
system which allows you to call specific station(s) only and prevent
unwanted stations from contacting you.
q Select the desired Tx code channel or 5-tone code according to
your System Operator’s instructions.
• This may not be necessary depending on programming.
w Push the call switch (assigned to one of the dealer programma-
ble switches: [Upper] and [Lower], etc.).
e After transmitting a 5-tone code, the remainder of your commu-
nication can be carried out in the normal fashion.
To Next Page
Loading...
