1
PANEL DESCRIPTION
C.Tone CH ENT
// only for the Simple type and 10-key type transceivers //
Push to enter the continuous tone selection mode. Select ➥
the tone frequency or DTCS code using [CH Up] or [CH
Down].
TALK AROUND
Push to turn the Talk Around function ON or OFF. ➥
• The Talk Around function equalizes the transmit frequen-
cy to the receive frequency for transceiver-to-transceiver
communication.
WIDE/NARROW
Push to toggle the channel passband width between wide ➥
and narrow.
DTMF AUTODIAL
< for the Non-display type transceivers >
Push to transmit the preprogrammed DTMF code. ➥
< for the Simple type and 10-key type transceivers >
Push to enter the DTMF number selection mode. Then se- ➥
lect a DTMF number by pushing [CH Up] or [CH Down].
After selecting the DTMF channel, push again to transmit ➥
the selected DTMF code.
RE-DIAL
Push to transmit the last-transmitted DTMF code. ➥
NOTE: TX memories are cleared after turning OFF the
transceiver.
CALL
Push to transmit a 2-Tone or 5-Tone in the operating chan- ➥
nel.
CALL A (CODE 1)/CODE B (CODE 2)
// only for the LMR model //
Push to transmit a 2-Tone, that is programmed in channel ➥
1 (Code A) or channel 2 (Code B).
CALL A (CODE 30)/CODE B (CODE29)
// only for the PMR model //
Push to transmit a 5-Tone as a station code, that is pro- ➥
grammed in channel 30 (Code A) or channel 29 (Code B).
EMERGENCY
Hold down during the Emer SW ON timer period to turn ➥
ON the Emergency function.
• After the Start or Repeat timer period ends, an Emer-
gency call is automatically transmitted once, or repeat-
edly, depending on the
presetting
.
Hold down during the Emer SW OFF timer period to can- ➥
cel the Emergency function, before transmitting an Emer-
gency call.
To Next Page
Loading...
Need help?
General
