3
DEALER-PROGRAMMABLE FUNCTIONS
6
DD
DTMF RE-DIAL FUNCTION
This function allows you to transmit the last-used DTMF code
at the push of a key.
To activate the function:
Push the [DTMF RE-DIAL] switch momentarily.
•The previously transmitted DTMF code is automatically transmitted.
•If no code has been transmitted since turning the power ON, this
function does not activate.
DD
HIGH/LOW POWER OUTPUT
This function selects high or low power for a channel.
To toggle between high and low power:
Push the [HIGH/LOW] switch.
•“LOW” appears when low output power is selected.
DD
EMERGENCY FUNCTION
The emergency function allows you to send your ID quickly
and easily to your Base Station, etc. in case of emergency.
To activate the emergency function:
Push and hold the [EMERGENCY] switch for 1 sec.
•The transceiver selects a pre-programmed channel, then sends an
emergency signal to your Base Station.
•The pre-programmed channel remains selected until a control signal
is received from the Base Station or power is turned OFF.
•The emergency call is repeatedly transmitted at pre-programmed in-
tervals.
DD
DISPLAY LIGHTING
The function display has 3 backlight conditions.
OFF: No backlight is available.
AUTO:When any key is pushed, the backlight turns ON for 5
sec. automatically.
CONTINUOUS: Backlight turns ON continuously after power
ON.
DD
SmarTrunk II
TM
functions
This transceiver provides SmarTrunk II™ functions.
(Optional UT-105
SmarTrunk II
TM
Logic Board is required.)
The optional UT-105 allows communication over conventional
channels or SmarTrunk II™ channels. Select a channel bank
for SmarTrunk II™ before trunking operation.
To toggle SmarTrunk II
TM
channels and conventional chan-
nels.
Push the [Bank Up] switch one or more times.
•Scanning starts when a channel bank for SmarTrunk II™ is se-
lected.
•Contact your dealer for channel bank details.
(See p.9 for more detailed operation.)
To Next Page
Loading...
Need help?
General
