Icom IC-F30 User Manual

IMPORTANT
READ ALL INSTRUCTIONS carefully and completely before
using the transceiver.
SAVE THIS INSTRUCTION
MANUAL-This instruction man-
ual contains important operating instructions for the IC-F30,
IC-F30LT, IC-F40 and IC-F40LT.
FOREWORD
Thank you for purchasing the IC-F30/LT VHF or IC-F40/lT
UHF TRANSCEIVER. There are versions of these for both
the LMR and PMR markets.
Note that the IC-F30/F40 function the same as the
''IT'' ver-
sions with the exception that they have no keypad or function
display, and therefore functions which require a keypad
(DTMF tones, etc.) are not available.
An optional UT-82 DTMF
KEYPAD is available for keypad functions.
E
Versions of these transceivers which display the
C
"CE" symbol on the serial number seal, comply
with essential requirements of the 89/336/EEC di-
rective for Electromagnetic Compatibility.
CAUTIONS
it WARNINGI NEVER connect the transceiver to an AC
outlet. This may cause a fire hazard or result in an electric
shock.
it WARNINGI NEVER hold the transceiver so that the an-
tenna is very close
to, or touching exposed parts of the body,
especially the face or eyes, while transmitting. The trans-
ceiver will perform best
if the microphone is 5 to 10 cm away
from the lips and the transceiver is vertical.
NEVER operate the transceiver near unshielded electrical
blasting caps or
in an explosive atmosphere.
NEVER expose the transceiver to rain, snow or any liquids.
NEVER place the transceiver where normal operation of a
vehicle may be hindered or where is could cause bodily
in-
jury.
NEVER disassemble the transceiver. Incorrect reassembly
may result
in a fire hazard or electric shock.
For U.S.A. only
Caution: Changes or modifications to this transceiver, not ex-
pressly approved by Icom Inc., could void your authority to
operate this transceiver under FCC regulations.

Icom IC-F30 Specifications

General

Brand	Icom
Model	IC-F30
Category	Transceiver
Language	English