Icom IC-F3100D series

■ Setting the Beep level
The beep function can be turned ON or OFF, and its level can be
adjusted between 1 and 5, or 1 (linked) and 5 (linked). When a
Linked option is selected, the beep level is adjustable with [VOL].
q Rotate [VOL] to turn the trans-
ceiver power OFF.
w Set [ROTARY SELECTOR] to
any channel other than Chan-
nel 16.
e While holding down [Lower], ro-
tate [VOL] to turn ON the power
and enter the beep level adjust-
ment mode.
r Push [Upper] to change the beep
level, or push [Lower] to turn the
beep function ON or OFF.
• The adjustable range is 1 to 5 or
1 (Linked) to 5 (Linked).
• If the level is set on 1 to 4 or 1
(Linked) to 4 (Linked), pushing
[Upper] increases the level.
If the level is 5 or 5 (Linked), 1 (Linked) or 1 is selected after push-
ing [Upper], respectively.
• A beep sounds after pushing [Upper]. Therefore, you can deter-
mine the current level setting by the type of beep that sounds.
• One beep sounds when the beep function is turned ON after push-
ing [Lower].
t Rotate [VOL] to turn OFF the transceiver, then ON again to exit
the beep level adjustment mode.
NOTE: This operation may not be available, depending on the
presetting. Ask your dealer for details.
20
3
BASIC OPERATION
3
[VOL]
[Lo
wer]
[ROTARY SELECTOR]