Icom IC-F6062 Instruction Manual

6
1
PANEL DESCRIPTION
TALK AROUND KEY
Push to turn the talk around function ON and OFF.
•Thetalkaroundfunctionequalizesthetransmitfrequencytothe
receive frequency for transceiver-to-transceiver communication.
WIDE/NARROW KEY
Push to toggle the IF bandwidth between wide and narrow.
•Thewidepassbandwidthcanbeselectedfrom25.0or20.0kHz
using the CS-F3160/F5060 c l o n i n g s o f t w a r e . (PMR operation
only) Ask your dealer for details.
DTMF AUTODIAL KEY
Push to enter the DTMF channel selection mode. Then select
the desired DTMF channel using [CH Up]/[CH Down].
After selecting the DTMF channel, push again to transmit the
selected DTMF code.
RE-DIAL KEY
Push to transmit the last-transmitted DTMF code.
•TXmemoriesareclearedafterturningthetransceiverOFF.
CALL KEYS
Push to transmit a 2/5-Tone/BIIS ID code.
•Call transmission is necessary before calling another station
depending on your signalling system.
•[CallA]and/or[CallB]maybeavailablewhenyoursystememploys
selective ‘Individual/Group’ calls. Ask your dealer which call is
assigned to each key.
EMERGENCY KEY
Hold down for a preset time period to transmit the emergency
call.
•The emergency call transmits with beeps;the display does not
change.
•Thetransceivercantransmittheemergencycallsilentlyorwiththe
display changes depending on the pre-setting. Ask your dealer for
details.
•Ifyouwanttocanceltheemergencycall,holddownthekeyagain
before transmitting the call.
•Theemergencycallistransmittedonetimeonlyorrepeatedlyuntil
receiving a control code, depending on the presetting.
SURVEILLANCE KEY
Push to turn the surveillance function ON or OFF.
WhenthisfunctionisturnedON,thebeepisnotemittedand
the LCD backlight and the LED indicator do not light when a
signal is received or a key is pushed.
TX CODE ENTER KEY (PMR operation only)
Push to enter the ID code edit mode directly, for both
5-Tone and MSK. Then set the desired digit using [CH Up]/
[CH Down]. (p. 11)
TX CODE CHANNEL SELECT KEY
➥ Push to enter the ID code channel selection mode
directly. Then set the desired channel using [CH Up]/
[CH Down]. (p. 10)
➥ During ID code channel selection mode, hold down for
1 second to enter the ID code edit mode for 5-Tone and
MSK. Then set the desired digit using [CH Up]/[CH Down].
(p. 11)

Icom IC-F6062 Specifications

General

Brand	Icom
Model	IC-F6062
Category	Transceiver
Language	English