9
2
BASIC OPERATION
n Clock function
The transceiver indicates the current time and date when
[Clock] is pushed. And you can change the indication format
and time/date settings.
When you use the transceiver for the first time, or after
the transceiver has sat unused for a long time, make sure
to check the date and time indication after turning the
power ON. If the time and date are not correct, reset
them. (p.10)
D Time and date indication
q Push [Clock] to indicate the current time and date on the
LCD.
•Whentheindicationformatissetto12-hour,“AM”or“PM”is
indicated.
•TheLCDindicationreturnstothestand-bymodeafter30sec.
has passed with no operation.
12HR 12:00PM
YMD08-04-01
The time indication format (12-hour/24-hour)
Time
Date
Date indication format (Y: Ye ar, M: Month, D: Day)
w Push [Clock] again to return to the stand-by mode.
D Time and date settings
q Push [Clock] to indicate the current time and date on the
LCD.
w Push and hold [Clock] for 1 sec. to enter the time and date
setting mode.
•Thetimeindicationformat,“24HR”or“12HR”blinks.
e Push [Clock] to select the desired item to be changed.
r Push [CH Up] or [CH Down], or rotate [CH Up/Down]* to
set the selected item.
*Simple type only
To Next Page
Loading...
Need help?
General
