Icom IC-F9020 Series Operating Guide

8
1
PREPARATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
DIGITAL BUTTON KEY* “DSEL”
➥ Push to enter the digital call type selection mode, then
push [CH Up]/[CH Down] or rotate [CH Up/Down] to
select a desired call type from “PAG E ,” “RDO INHIBIT,”
“RDO UINHIBIT,” “RDO MONITOR,” “RDO CHECK,”
“STATUS,” “SHORT MSG,” “STATUS QUERY,” “ PHONE”
and “ANNOUNCEMENT.” (p. 25)
After making the digital call type selection, push this key
again to enter the ID selection mode.
• If “STATUS” or “SHORT MSG” is selected, the transceiver dis-
plays the Status Message or Short Message selection mode
before entering the Individual ID selection mode.
• If “PHONE” is selected, the transceiver displays the phone num-
ber selection mode.
• If no operation is performed for about 30 seconds, the transceiv-
er returns to normal operation.
➥ Hold down for 1 second to cancel and return to normal op-
eration.
DIGITAL STATUS KEY* “STAT” (p. 45)
➥ Push to enter the Status Message selection mode.
After selecting, push again to enter the destination
Individual ID selection mode to send a Status Message.
• If no operation is performed for about 30 seconds, the transceiv-
er returns to normal operation.
• While in the Trunking mode, the Individual ID selection mode
does not appear.
➥ Hold down for 1 second to cancel and return to normal op-
eration.
DIGITAL PAGE KEY* “PAGE” (p. 35)
➥ Push to enter the Individual ID selection mode for a Page
call. Then push [CH Up]/[CH Down] or rotate [CH Up/
Down] to select a desired Individual ID.
• Push [PTT] to transmit a Page call.
• If no operation is performed for about 30 seconds, the transceiv-
er returns to normal operation.
➥ Hold down for 1 second to cancel and return to normal op-
eration.
DIGITAL MESSAGE KEY* “MSG” (p. 47)
➥
Push to enter the Short Message selection mode.
After selecting, push again to enter the destination
Individual ID selection mode to send a Short Message.
• If no operation is performed for about 30 seconds, the transceiv-
er returns to normal operation.
• While in the Trunking mode, the Individual ID selection mode
does not appear.
➥ Hold down for 1 second to cancel and return to normal op-
eration.
PHONE KEY* “PHON” (p. 51)
➥ Push to enter the phone number selection mode for a
Phone call. Then push [CH Up]/[CH Down] or rotate [CH
Up/Down] to select a desired phone number.
• Push [PTT] to transmit the Phone call.
• If no operation is performed for about 30 seconds, the transceiv-
er returns to normal operation.
➥ Hold down for 1 second to cancel and return to normal op-
eration.
* Not available on Non-display types.

Icom IC-F9020 Series Specifications

General

Brand	Icom
Model	IC-F9020 Series
Category	Transceiver
Language	English