Icom IC-T22E - Page 22

bane
mm 4 = ADVANCED FUNCTIONS
@ Memory/call channels
The transceiver has 40 memory channels (plus 3 pairs of
scan edge channels) and 1 call channel for storage of often-
used frequencies. Memory names can be assigned to each
channel, however, when you don’t need memory names, the
number of memory channels can be increased to 80.
The following can be programmed into memory/call channels:
* Operating frequency
* Duplex direction and offset frequency (pgs. 15, 16)
* Subaudible tone encoder*' (or optional’? tone squelch)
ON/OFF and its frequency (pgs. 15, 30)
+ Skip intormation
* Memory name
“Optional for Eur. and Italy versions; **Standard for U.S.A. version.
© Available memory channels « POWER ON
The number of memory channels available can be toggled
between 40 and 80 (not including scan edge pairs and the
call channel).
Y CAUTION: Selecting the number of memory channels
Z clears all memory contents and set mode settings.
‘» Push [FUNC] + [A] + [VFO] + [POWER] to set available
memory channels to 80 (memory names cannot be used).
‘* Push [FUNC] + [V] + [VFO] + [POWER] to set available
memory channels to 40 (memory name function available).
© Programming during selection
Y NOTE: Perform steps @ and @ below within 2 sec., other-
Z wise programming will not be successful.
@ Push [VFO] to select VFO mode.
@ Set the desired frequency:
‘Set other data, such as re-
peater information, etc. if re-
quired,
@ While pushing and holding [FUNC]
(until step @), push [(ma)MW] mo-
mentarily to indicate memory
channels,
+ “(i)” flashes.
*Do not hold [MW] for more than 0.5
sec., otherwise the memory channel
will overwrite the displayed number.
@ Rotate [DIAL] to select the desired
channel.
* Call channel and scan edge channels,
as well as regular memory channels,
can be programmed in this way.
© While continuing to push [FUNC], push [(ma)MW] for 0.5
sec. to program.
+ “{" stops flashing.