Icom IC-T22E - Page 23

© Programming after selection
® Select the memory channel to be programmed:
‘» Push [MR] to select memory mode.
‘» Rotate [DIAL] (or use the keypad) to select the memory
channel.
® Set the desired frequency in VFO mode:
‘» Push [VFO] to select VFO mode.
‘» Set the desired frequency using the keypad or [DIAL].
‘> Set other data, if desired.
® Push [FUNC] + [(ma)MW] for 0.5 sec. to program.
© Memory/call = VFO
@ Select the memory/call = pe
channel to be transferred: Wy GA Hit An
Push [MR] (or [CALL])
to select memory (call)
mode. Rengpnene
»
Rotate
[DIAL]
(or
use
+
=
the
keypad)
to
select
the
(<>)
GRA
-
'
“VF”
appears
briefly
memory channel.
@ Push [FUNC] + [(mR)MW]
for 0.5 sec. to transfer.
+ “VF” appears briefly and VFO
mode is selected.
VFO mode selected
ADVANCED FUNCTIONS 4
© Memory/call = call/memory
@ Select the memory/call channel to be transferred:
=» Push [MR] (or [CALL]) to select memory (call) mode.
‘» Rotate [DIAL] (or use the keypad) to select the memory
channel.
@ While pushing and holding [FUNC] (until step @), push
[(mA)MW] momentarily to indicate memory channels.
“VF” appears and “i” flashes.
* Do not hold [MW] for more than 0.5 sec., otherwise the memory
channel will overwrite the displayed number.
@ Rotate [DIAL] to select a memory channel to transfer the
data.
@ While continuing to push [FUNC], push [(mR)MW] for 0.5
sec. to program.
+ “(ill" stops flashing.
© Memory clear
® Push [MR] to select memory mode.
® Select the memory channel to be cleared.
® Push [FUNC] + [(vFo)M CL] for 0.5 sec.
¢“.-----" appears briefly in place of the frequency, the memory is
cleared and the next programmed memory is automatically se-
lected.
* Scan edges and memory channel 1 cannot be cleared.
Y NOTE: Be careful — the contents of cleared memories
“4 CANNOT be recalled.
NS