35
9
SUBAUDIBLE TONES
D Setting subaudible tones for tone squelch operation
Separate tone frequencies can be set for tone squelch operation
rather than repeater operation (the same range of tones is avail-
able— see below). Like the repeater tones, these are set in set
mode.
q Select VFO or memory channel.
w Push [A•
FUNC
], then push [8•
SET
] to enter set mode.
e Push [∫] or [√] several times until “Ct” ap-
pears when selecting CTCSS, or “dt” ap-
pears when selecting DTCS.
•“ ” flashes when selecting CTCSS, or “”
flashes when selecting DTCS.
r Rotate [VOL] to select the desired subaudible tone.
t Push [#•
ENT
] to program the selected tone and exit set
mode.
When
SET MODE
is selected from memory mode.
y Push [A•
FUNC
], then push [C•
MR
] for 1 sec.
• 3 beeps are emitted.
• VFO mode is selected automatically.
u Push [A•
FUNC
], then push [C•
MR
] for 1 sec.
• 3 beeps are emitted.
Steps y and u are necessary when overwriting the memory con-
tents permanently. The set tone frequency is used for temporary
operation only, therefore,these steps are not necessary.
• Available CTCSS tone frequency list
To Next Page
Loading...
Need help?
General
