Icom IC7300 - User Manual

ICOM – IC7300 – QUICK START OPERATING GUIDE
By K7HCP
The ICOM IC-7300 is an HF + 6 meter, multi-mode, self-contained Software
Defined Radio (SDR) transceiver with knobs, buttons and a touch screen. It also
has a real-time spectrum display with pan adapter and water fall displays.
It stands alone and does not require attachment to a computer to function like
most SDR radios in the past.
However to operate this radio using digital mode computer software such as
WSJT-X (FT8) or DigiPan (PSK31) all that is required is a single USB cable with NO
other digital interface hardware required such as sound card interface device.

Icom IC7300 Specifications

General

Modes	SSB, CW, RTTY, AM, FM
Receiver Type	Direct Sampling
Antenna Connector	SO-239
IF DSP	Yes
Real-Time Spectrum Scope	Yes
Power Supply	13.8V DC ±15%
Frequency Range	0.030–74.800 MHz
Display	4.3-inch Color TFT Touchscreen
Receiver Selectivity	SSB: 2.4 kHz/–6 dB, 3.6 kHz/–60 dB
Dimensions	240 x 95 x 240 mm

Summary

Getting Started

Basic Controls and Frequency Adjustment

Initial setup of power, AF/RF gain, and using the main dial to change frequency.

Changing Bands, Mode, and Filters

Instructions for selecting frequency bands, operating modes, and filter settings via the touch screen.

Displaying Spectrum Scope

How to activate and utilize the spectrum scope feature for signal monitoring.

Changing Frequency Methods

Methods to adjust the transceiver frequency using the main dial, spectrum scope, or memory channels.

Displaying Meters

Procedure to access and view the radio's meter displays.