ICON iKeyboard 4X User Manual

9
Getting Started
Connecting your iKeyboard X controller
1. Connect the ikeyboard X to your Mac/PC via the USB port.
 Choose a USB port on your Mac/PC and insert the wide (at) end of the USB cable. Connect
 the cable’s small jack end to the ikeyboard X. Your Mac/PC should automatically “see” the
new hardware and notify you that it is ready to use.
2. Mode select & assign the MIDI messages to iKeyboard X with iMap
software
 Select Mackie Control or HUI mode from the pull down menu for pre-mapped MIDI mapping.
 Select User Dened mode for self MIDI assignment. Refer to P.25 for “Assign the MIDI
 messages with “iMap
TM
” software.

 Tip: Make sure you have selected the correct DAW mode in the pull down menu.
3. Setup your DAW
 Activate the ICON iKeyboard X controller in your DAW or MIDI software using “MIDI Setup”
or “MIDI Devices”.
 For Logic
TM
, Cubase
TM
and Nuendo
TM
, choose Mackie Control at the “Device List”.

 (Note: Every application does this a little different, so refer to your software user manual for
the settings.)

ICON iKeyboard 4X Specifications

General

Brand	ICON
Model	iKeyboard 4X
Category	Recording Equipment
Language	English