38
(Tip: Platform B+ will memories your last selected DAW mode and re-enter the
same mode a few seconds after it has been switched on. (i.e. DAW mode selection
is not needed if the last mode is being used.)
4. Select the DAW at Platform B+
Press the DAW button according to the DAW you are using to select the DAW mode.
Press one of the 4 mode button according to your DAW as the below table.
MCP LogicPro HUI UserDene
1. Nuendo/Cubase Logic Pro ProTools User self mapping with iMap
2. Digital Performer
3. FL Studio
4. SamplitudePro
5. Reaper
6. Studio One
7. Bitwig
8. Reasons
9. Sonar
10. Audition
11. Ableton Live
5. Setup your DAW
The Platform B+ has built-in Mackie Control, LogicPro and HUI protocol, which will
save you considerable trouble in setting up the device at your DAW. Simply add the
“Mackie Control” or “HUI” device under the “MIDI Controller” on your software. After
the Mackie Control or HUI device has been added, select Platform B+ controller as
your MIDI input and output device in your DAW.
(Tip: You may also refer to our website at www.icoproaudio.com, where you’ll nd
set up illustrations for different DAW’s in each controller (Platform B+) product page’s
“Setup demo” section.
For DAW’s not on our setup demo list, please refer to your software user manual for
hardware setup.)
4
To Next Page
Loading...