57
Assigning DAW Mode (Mackie control/
LogicPro/HUI) Using iMap
TM
To begin DAW mode setup, connect your Platform B+ with iMap. Follow the
steps below:
1. Connect Platform B+ to your Mac/PC.
2. Launch iMap and click “Connect Device”.
Note: If your Platform B+ is not connected to your Mac/PC, the message
“There are no MIDI input devices” will appear. Please connect Platform B+ to
your Mac/PC with the provided USB cable.
iMap
TM
Platform B+ software panel
Diagram 7
3. Select “Platform B+” at the pop-up menu as your MIDI out
device.
2
3
1
To Next Page
Loading...