58
4. According to your DAW, select the DAW Mackie/HUI protocol
mode from the “Mode” pull-down menu. Different DAW
modes are listed below:
1. MCP
2. LogicPro
3. HUI
Tip: You may also use the hardware to select DAW instead of through iMap.
Please refer to P.37 for instructions.
5. After you have nished creating all settings, click “Send Data”.
6. Close iMap.
(Note: Please make sure you have disconnected from the USB connection after
setup if you are using Platform B+ with Platform M+.)
To Next Page
Loading...