Kill-Out Statistics
After pressing *WGT STATS, *DRAFT TOT or *DRAFT WGTS, the corresponding weight
statistics are displayed. A press of the key will now re-display these weight statistics,
applying the Kill-out Percent setting (accessed in SET-UP) to the weights:
For example:
AVG WT % = 297kg
TOT WT % = 21384
Exit From Statistics
Press the key to exit back to the weighing mode.
“What If” Drafting Statistics
Since statistics are recalculated on entry to the statistics display functions, the operator
may change the draft limits and re-examine the drafting statistics to determine how many
animals would have been drafted into each weight range with different settings.
ICONIX FX PRINTER OPTION
The Iconix FX Printer is a rugged, portable printer that uses standard adding machine
paper rolls. It is powered from the internal battery of the FX41 indicator. Note that use of
the printer reduces the number of hours of operation before recharging is required.
Switch OFF the FX41, then attach the printer cable to the “OPTIONAL I/O” connector
on the back of the FX41.
Switch ON the FX41 and check that PRINTER ON-LINE is selected in SET-UP.
Check and select if necessary the required group file using the GROUP key. If a
printout is required of all records in memory, or the statistics for all records, select
Group 0 before doing the printouts. See the section GROUP FILES - Using the
Global Group File.
Press the ON-LINE key on the printer to light the ON-LINE lamp.
Press , then *PRINT STATS for a full statistics printout for the selected group.
Press , then *PRINT RECS to print all records in memory for the selected group.
To print the records arranged in ID order, select "PRINT BY ID".
To print the records arranged in weight order, select "PRINT BY WEIGHT".
Using The Printer On-Line During A Weighing Session
The FX Printer may be used to print a record as each animal is weighed, rather than at
the end of a weighing session. Each time WEIGH is pressed, a new record will be
printed.
NOTE: Use of the 25 pin “Optional I/O” Connector
This connector is reserved for the use with the Iconix FX Printer, the Iconix AutoDrafter
and Allflex EID readers. DO NOT ATTACH ANY OTHER EQUIPMENT, as damage is
likely due to the power supply voltages brought out on to this connector.
Page 10 FX41 User Manual 08May08
To Next Page
Loading...
