4. GROUP FILES
A new record is stored (in permanent memory) in the selected group (mob file) whenever
WEIGH is pressed. A record consists of :
Weight, Group, Date, ID (if used), Condition Code (if used)
The FX41 has an in-built clock-calendar and the date is automatically recorded every
time WEIGH is pressed.
In normal operation, before starting a new weighing session, the operator would select a
previously unused group from the range 1 – 99. At the end of the session, or at any time
during, the statistics for the group may be displayed or printed. Individual records for the
selected group may also be printed.
Memory Capacity: 6000 weighing records plus
3000 EID/VID Cross-Reference Table records
The weighing records capacity may be shared between the groups in any manner. i.e.
any number of groups may be used with any number of records in each, providing the
total number of records does not exceed 6000. To check the total number of records that
have been used, press the key, then *RECS USED.
When the record limit is reached, the message "MEMORY FULL !" will be displayed
when the WEIGH key is pressed again. No more records are able to be stored until some
or all of the existing records are cleared. Usually records from a previous weighing
session (stored in another group) can be cleared so that more records can be added to
the currently selected group.
A press of the GROUP key shows the currently selected group (mob file) and the date of
the most recent weighing for the group.
For example:
GRP=28 25AUG01
NEW #, (ENTER), or
To exit from group file display, press GROUP again or press ENTER.
At switch-on the last used group file remains selected, as indicated during start-up.
SELECTING GROUP FILES
Press GROUP to display the currently selected file number. For example:
Type new file no.: 2 9
GROUP (0 - 99) = 29
(ENTER) WHEN OK
Press ENTER
GRP=29 NO RECORDS
NEW #, (ENTER), or
The display advises that there are no records in Group 29. Press ENTER to accept this
group file selection and return to the normal operating mode. Group files may be selected
from the range 1 to 99.
FX41 User Manual 08May08 Page 7
To Next Page
Loading...
