Copyright © 2014 ICP DAS Co., Ltd. All Rights Reserved. ∗ E-mail: service@icpdas.com - 33 -
Modbus Connection
In the Modbus Conncetion section, it provides the scan time information for each COM port
(available in firmware 1.08 and later). The Master device can refer to the scan time to extend or
shorten the time interval for each requesting data command.
Expand the polling definitions by clicking [+COMn] item, information including the polling definition
number, SlaveModbusID, Starting Address of Register and Count of Register on both slave client and
MDC-700, and the connection status are provided.
NOTE The contents of the section may be different depending on the settings
in the config.csv file.
To Next Page
Loading...
