ICP DAS USA MDC-700 Series

To Next Page

To Previous Page

2. Upgrade Firmware using the MiniOS7

The firmware update requires a TCP/IP connection. Connect the MDC-700 to a network

whenever possible.

Step 1: Use an Ethernet cable to connect the MDC-700 to the computer

After plugging the Ethernet cable, the Link/Act and 10/100 indicator LEDs come on or

start flashing to indicate a connection was made.

Step 2: Establishing a connection between the MiniOS7 Utility and the MDC-700

Launch the MiniOS7 Utility and then select New Connection on the Connection menu.

On the “Connection” tab of the “Connection” dialog, select “TCP” from the dropdown list,

type the IP address of MDC-700, and then click OK button.

ICP DAS USA MDC-700 Series - Page 53