Figure 12 1Unconverted Factory Configuration as viewed in the Horizontal Left Orientation
Remove trap from collector
t f alternate vent position box.
is required, loosen clamp
on vent elbow inlet.
trap.
ID
Remove relief tube from
relief port on condensate
Remove front pressure
switch tube and discard.
(_ emove relief tube
from port on collector --
box.
Remove middle and right
plug from collector box.
(1 AND 2 STAGE UNITS)
Horizontal Left Trap Configuration
(_ otate elbow todesired position
and torque clamp
on inlet 15 Ib-in.
Install plug in open
ports on collector box.
Connect relief tube to port
on collector box.
(_ Slide relief tube instand-offs to adjust
length.
Connect tube from Loose
Parts bag to port on front
pressure switch.
(_ ttach condensate
trap with screw to
collector box.
Route pressure switch tube
underneath relief tube and
connect to port on
collector box.
(_ Align trap over middle
and right-hand port on
collector box.
(1 AND 2 STAGE UNITS)
Connect relief tube to relief
port on condensate trap.
Al1282
Condensate Drain Connection
Upflow/Downflow Orientation
In the Upflow or Downflow orientation, the condensate trap is
inside the furnace casing. The condensate drain must be
routed from the trap through the furnace casing. The
condensate drain can be routed through the left or right side of
the casing. (The left or right side is as you are viewing the
furnace.) The furnace condensate drain can be connected to
the Air Conditioning condensate drain as shown in Figure 13.
NOTE: On narrower casing, it may be easier to remove the
condensate trap, connect the drain line components and
re-install the condensate trap. Read the steps thoroughly to
familiarize yourself with the required steps.
16 specificati..... bject to change withoutnotice. 440 01 4001 02
To Next Page
Loading...
