To Next PageTo Next Page
Need help?Do you have a question about the ICP G9MAE0601714A and is the answer not in the manual?
General| Model Number | G9MAE0601714A |
|---|---|
| Category | Furnace |
| Brand | ICP |
| Fuel Type | Natural Gas |
| Heating Capacity | 60, 000 BTU |
| Ignition Type | Hot Surface Ignition |
| Weight | 120 lbs |
Signal words used throughout this manual to identify hazard levels.
Signal words used in combination with colors and/or pictures or product labels.
Warning about potential hazards from improper installation, adjustment, alteration, service, or use.
Warning about potential injury or death from electrical hazards during service.
Warning about hazards related to carbon monoxide and fire.
Caution regarding sharp edges on sheet metal parts.
Section for recording startup parameters for heating operation.
Section for recording startup parameters for cooling operation.
Essential electrical and gas supply requirements before furnace operation.
Guide to configuring furnace settings via DIP switches for application requirements.
Procedure to fill the condensate trap with water before operation.
Instructions for purging gas lines and checking for leaks.
Information on furnace electrical connections, wiring diagrams, and control board LEDs.
Instructions for cleaning or replacing the furnace air filter.
Procedures for cleaning the blower motor and wheel for optimal performance.
Procedure for cleaning the furnace burners for proper combustion.
Instructions for cleaning the flame sensor for reliable ignition.
How to test the hot surface igniter's resistance before removal.
Steps for removing and replacing the hot surface igniter assembly.
Cleaning the collector box and its associated drainage components.
Procedures for cleaning the condensate drain line and trap.
Verifying the function of the condensate heat pad if installed.
Information regarding the serviceability of secondary heat exchangers.
Procedures to prepare the furnace for cold ambient temperatures.
Explanation of the service label and its role in troubleshooting.
How to access and interpret stored diagnostic codes from the control.
A step-by-step guide for diagnosing furnace operational problems.
Warning about potential intermittent unit operation due to grounding issues.
How the furnace operates with a communicating control system.
Furnace operation with a single-stage thermostat in modulating mode.
Operation of the furnace in single-speed cooling mode.
Furnace operation with a two-stage thermostat in cooling mode.
How the furnace operates when a dehumidification demand is present.
Operation of the blower in continuous circulation mode.
Furnace control logic for operation with a heat pump system.
List of parts belonging to the furnace casing.
List of electrical components for the furnace.
List of filter components.
List of parts related to the blower assembly.
List of gas control components.
List of parts for the heat exchanger assembly.
List of components related to the inducer assembly.
Breakdown of the product model number's meaning by digit position.
